如何清洗山東通風管道內亂七八糟的東西?

發布人：http://www.bnlfans.net   發布時間：2019-06-06 17:09:44

　　如何清洗山東通風管道內亂七八糟的東西?

　　How to clean the messy things in Shandong ventilation pipeline?

　　持續增長的通風管的使用時間,它會積累大量的雜質,這些雜質將存儲在管很長一段時間,在操作將加快石油凝結,溫度高,構成氣動閥的損壞,液壓和其他組件,在正常運行構成很大的影響。因此，有必要定期對通風管道設備進行清洗。你怎么清理它?山東通風管道為您介紹如下:

　　With the increasing use time of ventilation pipe, it will accumulate a large amount of impurities, which will be stored in the pipe for a long time. The operation will speed up the condensation of oil, high temperature, the damage of pneumatic valve, hydraulic and other components, which will have a great impact on the normal operation. Therefore, it is necessary to regularly clean ventilation pipeline equipment. How do you clean it? Shandong Ventilation Pipeline Expert will introduce you as follows:

　　(1)風管與風機連接時，應在出風口的進、出口處加軟接頭。軟接頭的截面尺寸應與風機的進、出口截面尺寸相同。軟管接頭可由帆布、人造革等材料制成。軟管長度不應小于200，密封性應適當。柔性軟管可以緩沖風機的振動。

　　(1) When connecting the air duct with the fan, soft connectors shall be added at the inlet and outlet of the air outlet. The cross-section size of the soft joint should be the same as that of the inlet and outlet of the fan. The hose joint can be made of canvas, artificial leather and other materials. The length of hose should not be less than 200 and the sealing should be appropriate. Flexible hose can cushion the vibration of fan.

　　(2)風管與除塵設備、加熱設備連接時，根據理論制圖，在設備和設備結束后，應暫停預制和設備。

　　(2) When the air duct is connected with dust removal equipment and heating equipment, according to the theoretical drawing, the prefabrication and equipment shall be suspended after the end of the equipment and equipment.

　　(3)濟南通風管道安裝時，進、出口風量天應在預制的開孔風道內，如果出風口在設備上風道的末端，則其接口應嚴密。

　　(3) When installing Jinan ventilation pipeline, the air volume of inlet and outlet should be in the prefabricated open air duct every day. If the outlet is at the end of the air duct on the equipment, its interface should be tight.

　　(4)輸送含冷凝水或含水量較大的氣體時，水平管道應設置坡度，并在低點與排水管道連接。安裝設備時，管道底部不應存在縱向接縫。

　　(4) When conveying gas containing condensate water or high water content, the horizontal pipeline should be gradient and connected with the drainage pipeline at the lowest point. When installing equipment, there should be no longitudinal joints at the bottom of the pipeline.

　　(5)輸送易燃易爆氣體的鋼板風道，在風道連接法蘭處安裝跳線，并與靜電接地網連接。

　　(5) The steel plate air duct for conveying flammable and explosive gases shall be connected with the electrostatic grounding grid by installing jumpers at the connecting flange of the air duct.

　　(6)水平風道高度在4m以上時，安裝人員應系好帶。腳手架或移動式腳手架在舷梯上應固定好，舷梯寬度應符合規范，腳手架上的設備人員應隨身攜帶包袋，避免東西或電鉆等掉落物受傷。

　　(6) When the height of horizontal duct is more than 4m, the installer should fasten the seat belt. Scaffolds or mobile scaffolds should be fixed well on the gangway, the width of the gangway should conform to safety standards, and equipment personnel on the scaffolding should carry bags with them to avoid injuries to falling objects such as things or electric drills.

　　(7)風管就位后，雙吊臂支撐應保證水平臂伸直，吊臂保持不變，雙吊臂受力均勻。

　　(7) After the air duct is in place, the support of double booms should ensure that the horizontal arm is straight, the boom remains unchanged, and the force of the double booms is uniform.

　　山東通風管道好每三個月清洗一次，既能保證正常運行，又能延長通風管道的使用壽命。如果您不明白清潔的問題，請到我們的網站電話咨詢，我們會及時回復您!

　　Shandong ventilation pipeline should be cleaned every three months, which can not only ensure normal operation, but also prolong the service life of the ventilation pipeline. If you do not understand the problem of cleaning, please call our official website for consultation, we will reply to you in time!