全部通風工程需求和水簾作用介紹

發布人：http://www.bnlfans.net   發布時間：2023-04-14 18:10:19

  風管就位前應查看全部支架的水乎度和標高、查看支架的牢固程度，風管就位可采用直接和吊具兩種辦法。對風管斷面較小，又方位較低的可采用人工就位辦法，只需搭設簡易腳手架即可。當風管斷面較大且管段較長時，可采用滑輪、倒鏈、大繩等辦法吊裝。

Before placing the air duct in place, the water level and elevation of all supports should be checked, and the firmness of the supports should be checked. There are two methods for placing the air duct: direct and lifting. For ducts with small cross-section and low orientation, manual positioning can be used, which only requires the installation of simple scaffolding. When the cross-section of the air duct is large and the pipe section is long, methods such as pulleys, chain blocks, and large ropes can be used for lifting.

主要靠纖維滲透和噴孔射流的獨特出風模式能均勻送風的送出風末端系統。具有面式出風，風量大，無吹風感；整體送風均勻分布；防凝露；易清潔維護，健康；美觀、色彩多樣，個性化突出；重量輕，屋頂負重可忽略不計；系統運行寧靜，改善環境品質；安裝簡單，縮短工程周期；安裝靈活，可重復使用；系統成本節省，性價比高等種種優點。

A unique air outlet system that relies mainly on fiber infiltration and orifice jet to evenly distribute air. Equipped with surface style air outlet, with high air volume and no blowing sensation; Uniform distribution of overall air supply; Anti condensation; Easy to clean and maintain, healthy and environmentally friendly; Beautiful, colorful, and personalized; Lightweight, with negligible roof load; Quiet system operation, improving environmental quality; Easy installation and shortened engineering cycle; Flexible installation, reusable; The system has various advantages such as comprehensive cost savings and high cost-effectiveness.

全部通風工程需求和水簾合作運用，在夏日酷熱的時分可將車間內溫度控制在28攝氏度以內。但人體的涼快感受可與空調比較，稍長時間對著水簾的人會感受冷而受不了。

All ventilation projects require cooperation with water curtains, and the temperature in the workshop can be controlled within 28 degrees Celsius during the scorching summer heat. But the coolness of the human body can be compared to air conditioning, and people who face the water curtain for a slightly longer time will feel cold and cannot bear it.

濟南通風管道在運輸過程應有防止損傷風管的保護措施。榫接風管的連接在榫口處涂膠粘劑，是為增強接頭處的強度。當風管采用地面預組裝后架空安裝時，限制預組裝的長度是為了遮免風管因自重產生的彎曲而破壞構件接口。玻璃纖維復合板風管端口為切割面時，在裝配法蘭連接件前應將管端切口面用膠帶或膠液進行封堵，才能防止玻璃纖維外露和飛散。

Ventilation ducts should have protective measures to prevent damage to the ducts during transportation. The connection of the mortise and tenon air duct is coated with adhesive at the mortise to enhance the strength of the joint. When the air duct is installed overhead after ground pre assembly, limiting the length of pre assembly is to prevent the bending of the air duct due to its own weight from damaging the component interface. When the end of the fiberglass composite board air duct is a cutting surface, the cutting surface of the pipe end should be sealed with tape or glue before assembling the flange connection to prevent the exposure and scattering of the fiberglass.

更多的關于濟南通風管道問題或者詳細的內容，請進入我們公司的網站：http://www.bnlfans.net網站中會有很多的內容僅供參考。

For more information or detailed information on the issue of ventilation ducts in Jinan, please visit our company's website: http://www.bnlfans.net There will be a lot of content on the website for reference only.