鍍鋅螺旋風管與玻璃鋼風管的性能比較

發布人：http://www.bnlfans.net   發布時間：2019-05-09 17:08:55

　　一、保溫性能對比：

　　1. Comparison of thermal insulation performance:

　　無機玻璃鋼風管：導熱系數大，無保溫性能，必須另外加包保溫層及保溫防護層，保 溫層特性同鍍鋅風管。

　　Inorganic fiberglass reinforced plastic duct: It has large thermal conductivity and no thermal insulation performance. It must be coated with thermal insulation layer and thermal insulation protection layer. The thermal insulation layer has the same characteristics as galvanized duct.

　　鍍鋅螺旋風管：導熱系數大，無保溫性能，需另外加包保溫層。

　　Galvanized spiral air duct: large thermal conductivity, no thermal insulation performance, need to add additional thermal insulation layer.

　　二、強度對比：

　　Strength contrast:

　　無機玻璃鋼風管：強度較高，但比較脆弱，應其較重，不易搬運，易受碰撞導致酥裂和破損， 因自重較大，水平面邊長較大時風管壁厚迅速增加，單位面積管壁重量大大增加，容易產生性豎向變 形和沉降（規范規定矩形無機玻璃鋼風管也應同按金屬風管的加固方法進行加固，其加固筋與風管應為相同的材料并成為一整體）。

　　Inorganic fiberglass reinforced plastics ducts: high strength, but relatively fragile, should be heavier, not easy to handle, vulnerable to collision leading to cracking and damage, because of heavy weight, large horizontal side length when the duct wall thickness increases rapidly, unit area wall weight increases greatly, prone to permanent vertical deformation and settlement (specification stipulates that rectangular inorganic fiberglass reinforced plastics ducts should also be added with metal ducts) The reinforcing bars and air ducts should be the same material and become a whole.

　　鍍鋅螺旋風管：強度較高，抗靜壓能力強，易搬運，受碰撞不會導致破損。

　　Galvanized spiral air duct: high strength, strong static pressure resistance, easy to transport, collision will not lead to damage.

　　三、防潮性能對比：

　　3. Comparisons of moisture-proof performance:

　　無機玻璃鋼風管：無法與有機玻璃鋼風管的防潮性能相比，受原料配比的制約，其防潮能 力的穩定性較差；受市場競爭的影響，為降低成本，使目前市場上出現的無機玻璃鋼風管絕大多數不能符 合相關標準。

　　Inorganic FRP duct: Compared with the moisture-proof performance of organic FRP duct, the stability of moisture-proof ability of inorganic FRP duct is poor due to the restriction of raw material ratio. Influenced by market competition, in order to reduce costs, most of the inorganic FRP ducts on the market can not meet the relevant standards.

　　鍍鋅螺旋風管：不適合在空氣潮濕性大的環境使用、在此種環境使用易腐蝕生銹。

　　Galvanized spiral air duct: It is not suitable for use in humid environment. It is easy to corrode and rust in this environment.

　　四、漏風量對比：

　　Comparisons of air leakage:

　　《規范》規定：風管漏風量應根據管道長短及其氣密程度，按系統風量的百分率計算。風管漏風率宜采用10%（對于一般送排風系統）玻璃鋼風管總長度50m以下時，其漏風率通常要達到 8-10%， 風管總長度增加時，漏風量要適當增加，當管內靜壓為500Pa時，風管單位面積漏風量為6m3 /h.m2 。

　　The Code stipulates that the air leakage rate of air duct shall be calculated according to the length of the duct and its air tightness, and the percentage of the air flow rate of the system. When the total length of FRP duct is less than 50 m, the air leakage rate usually reaches 8-10%. When the total length of duct increases, the air leakage rate should be increased appropriately. When the static pressure inside the duct is 500 Pa, the air leakage rate per unit area of duct is 6 m3/h.m2.

　　鍍鋅螺旋： 風管總長度50m以下時，其漏風量通常要達到 8%，風管總長度增加時，漏風量要適當增加。

　　Galvanized spiral: When the total length of air duct is less than 50m, the air leakage usually reaches 8%. When the total length of air duct increases, the air leakage should increase appropriately.

　　五、 防火性能對比：

　　Fifth, fire protection performance comparison:

　　無機玻璃鋼風管：無機玻璃鋼風管屬不燃材料，但其保溫材料是否燃燒要依材質而定，通 常選用離心玻璃棉等不燃保溫材料，而聚苯乙烯板等則不能滿足要求。

　　Inorganic FRP duct: Inorganic FRP duct belongs to non-combustible material, but its thermal insulation material depends on the material. Usually, centrifugal glass wool and other non-combustible thermal insulation materials are selected, while polystyrene board can not meet the requirements.

　　鍍鋅風管：鍍鋅螺旋風管屬不燃材料，其保溫材料是否燃燒要依材質而定，通常要選用離心玻璃棉等不燃保溫材料。

　　Galvanized air duct: Galvanized spiral air duct belongs to non-combustible material. Whether its insulation material burns or not depends on the material. Usually, non-combustible heat preservation material such as centrifugal glass wool should be selected.

　　六、 消聲性能對比：

　　6. Comparison of noise attenuation performance:

　　玻璃鋼風管：無消聲性能，必須加裝消聲器，且需要更大的空間FRP duct: silence performance, muffler must be installed, and need more space鍍鋅風管： 無消聲性能，必須加裝消聲器，同玻璃鋼風管一樣，多占 用空間。

　　Galvanized air duct: silencing performance, muffler must be installed, as with FRP air duct, occupy more space.